I picked up this 767GX at a local fest with the 2m and 6m modules. 80 USD.

This is my first non-HT radio, so I’m very much in the learn-by-putting-my-fingers-in-the-mains-socket mode.

I have some soldering experience and recapped a few hi-fi recievers, so I’m only hugely intimidated by this puzzlebox of cable bundles and dense parts rather than paralyzed intimidated. The closest hi-fi analog I have is a ~1972 Kenwood KR-6200 with tiny PCBs and loose cables.

So far, experimenting with scrap wire off the main HF socket in RX mode (need to wire up a compatible mic and get some adapters to try appropriate antennae before transmitting), I’ve determined the following:

It tunes and emits audio. It’s the world’s most absurd way to pick up 620kHz AM.

My office equipment is a RF noise nightmare.

The battery memory is shot. CR2032 holders are on order already. Annoying that without memory, it defaults to 7MHz exactly, which is Extra-only.

It mechanically clatters and rattles like Dad’s old Toyota. People mentioned lubing the fan but not how to safely dismantle it TO lube it.

The encoder is shot, it just shakes the last digit erratically. Apparently common for the type. I don’t know how to dismantle the unit futher than this to jab at it. A few buttons (tune up, band down) were initially unresponsive but worked open. The knobs are a bit scratchy-- I’d try Deoxiting it but it seems to be improving through rework, and opening the front panel once was enough. :p

But here’s a zesty one: there’s a cable harness that’s unplugged inside the unit. It’s ziptied to one of the four big wires on the PCB that provides connectors for the 2m/6m/70cm modules. The cables look to short to reach much nearby, and I don’t see matching sockets nearby. It appears to be a 2-pin (brown, red) and 6-pin (two blank, orange, yellow, grey heatshrinked, white)

Does this support another option or has someone been monkeying around with it? It seemed one or two screws short when I started to follow the disassembly manual.

  • AG7LR@lemmy.radio
    link
    fedilink
    English
    arrow-up
    4
    ·
    3 days ago

    I don’t know anything about this radio, but the nice thing about older gear is that you can usually find a service manual for it. That should at least help you figure out where the wires go and if someone has modified it.

  • dhtseany@lemmy.ml
    link
    fedilink
    arrow-up
    3
    ·
    2 days ago

    A pic of the wire bundle in question world go far for getting more refined assistance.

  • skysurfer@lemmy.world
    link
    fedilink
    arrow-up
    4
    ·
    3 days ago

    I’m not familiar with the internals of that specific model but upvoted for visibility. I’m curious as well about your mystery connection.