Hope no one minds me being slightly off-topic in a relatively inactive group, but it’s the best fitting community I could find for the question.
I plan to build a directional wifi antenna using a can (aka the Pringles can antenna). I am baffled at how costly the connectors are. Why are the prices so high for a connector? Cantenna instructions always say to use an N-type connector. Is that really necessary? Coax cable connectors are a dime a dozen. Would those work?
Or what if I just strip the end of the coax cable to the right length and find a way to skip the connector and secure it to the can… will that work?
Otherwise it’s ~$12 for the panel mount N connector + $10 for the connector that mates to it + $10 for the RP-SMA connector that attaches to the wi-fi AP. So over $30 for a home built wi-fi antenna. Fuck that.
Yes, you can just strip the end of some coax to correct length for your frequency and stick that in a can. All the basic whip antennas on routers are just that in a plastic shell. As far as what kind and the related price of materials you use, doesn’t really matter if it works. If you live somewhere super noisy you might need to go all out and do everything “the correct way”. Anything rf these days has a lot of protections built in so it takes a lot to outright fry most Rx/tx hardware.
Just in case, for starters, this type of connector’s internal pin receptacles are normally plated in gold to ensure maximum conductivity and to prevent oxidation. There’s also likely brass, nickel, and teflon even, I believe.
And… this is a whole lot of ~6 GHz frequencies! Add to it a quite uncommon shape of a connector, it requires a dear complex manufacturing, too.Try aliexpress, it’s usually a lot cheaper for electronics parts.
You can probably buy a whole directional antenna on there cheaper than the cost of building one tbh.
