I had new progressive lenses made, but the old ones are still fine and don’t have a scratch. They’re just a bit weak at near distance, but otherwise perfectly serviceable.
So I made new frames for them because I don’t like to throw away things that work.
All assembled, the frames weigh 3.5 grams, and 14 grams with the lenses mounted.
This was printed with a Prusa Mk4 and regular PLA at 0.15 mm layer height. The hinges use simple 10x1 pins - and I worked my magic to print the holes horizontally to the final dimension with interference fit, so no reaming or drilling is necessary. These glasses are straight out of the printer with zero rework.
I think they look pretty good as they are. If anybody notices they’re 3D-printed, I’ll say I’m gunning for that particular style 🙂
The front of the frames prints in 11 minutes and both temples in 12 minutes. I could break and make a new pair every day for the rest of my life and it would still be faster and cheaper than going to Specsavers only once.
They are not perfectly round. They’re slightly elliptical - 38 mm / 40 mm diameters. I know that because they were mounted on a silver-nickel frame I made myself some 20 years ago with those dimensions, so I didn’t have to measure them.
I did have to make a couple of prints and take out a few tenths here and there to get a tight fit around the lenses because my 3D-printed grooves and the ones in my metal frames don’t have the same geometry. But it was only minor adjustments.