Definitely a donor board, the other side was worse (you can see the power switch to the right, it just fell off).

    • Shadow@lemmy.ca
      link
      fedilink
      English
      arrow-up
      3
      arrow-down
      1
      ·
      6 days ago

      Are you just using a hot air gun to desolder? That looks nice and clean.

      • v1605@lemmy.worldOPM
        link
        fedilink
        English
        arrow-up
        4
        ·
        6 days ago

        Thanks. Hot air in this case. The process I use for this is to add fresh leaded solder, then some extra flux. After that, just keep moving around the hot air nozzle.

        • Grass@sh.itjust.works
          link
          fedilink
          English
          arrow-up
          2
          ·
          6 days ago

          have you done any boards with plastic sockets? how do you not destroy them? I’ve been putting kapton tape and aluminum foil barriers on them but sometimes they find a way to melt anyway

          • Shadow@lemmy.ca
            link
            fedilink
            English
            arrow-up
            2
            ·
            edit-2
            6 days ago

            You can also get low temp solder, add that in, then desolder it easier.

          • v1605@lemmy.worldOPM
            link
            fedilink
            English
            arrow-up
            1
            ·
            6 days ago

            I’ve had luck using kapton around plastic parts. The fresh solder really helps melt the components quicker. I also use a nozzle to help concentrate the heat in the area and prevent it from blowing directly on plastic parts. Depending on the board, you can go no nozzle and heat from below (which is how I replaced a PS5 ribbon connector).

  • Pondis@lemmy.world
    link
    fedilink
    English
    arrow-up
    2
    ·
    5 days ago

    You can buy unpopulated motherboards on AliExpress, then you can move all the parts and make it a much more difficult job!

    • v1605@lemmy.worldOPM
      link
      fedilink
      English
      arrow-up
      2
      ·
      5 days ago

      I’m going to take the lazy approach approach and go with the funny playing board. I would also have to buy one of their slots anyway since this also had a few mangled pins.