The basket occasionally went in the dishwasher which cleaned the surface, but the well gunked grease has been building up.

Tried soaking the basket in soap and hot water. Scrubbing with a soft sponge. And then running the dishwasher multiple times but it only got a small part of the grease out.

    • geneva_convenience@lemmy.mlOP
      link
      fedilink
      arrow-up
      10
      ·
      2 days ago

      This is the other issue. Grease would come off using a metal sponge. But that would demolish the “antistick” coating which the grease is sticking to.

      I need something which dissolves the greases adhesion to the airfryer pan so a soft sponge can wipe it off.

      • TunaLobster@lemmy.world
        link
        fedilink
        arrow-up
        1
        ·
        4 hours ago

        The blue sponges that ate for non stick are softer than the normal green ones. The rough side of the blue ones are safe for non stick assuming your aren’t giving it everything you’ve got.

        These ones:

        • blackbrook@mander.xyz
          link
          fedilink
          arrow-up
          2
          ·
          8 hours ago

          One common, readily available, relatively unharmful type is citrus decreasers like Citrisolv or similar.

          • ReadMoreBooks@lemmy.zip
            link
            fedilink
            English
            arrow-up
            1
            ·
            8 hours ago

            Get the dangerous alkaline concentrate and dilute it as directed for the situation. It’s much cheaper. Whatever environmental concerns are canceled out because 1 gallon was transported instead of 64-128 gallons.

            • blackbrook@mander.xyz
              link
              fedilink
              arrow-up
              2
              ·
              7 hours ago

              I buy the orange stuff by the gallon because I can use it for bike chain degreasing, and woodworking ( as a solvent for oil finishes, etc.), etc.

              • ReadMoreBooks@lemmy.zip
                link
                fedilink
                English
                arrow-up
                1
                ·
                6 hours ago

                When we want to break hydrocarbon chains we use bases by default. But, I’d not use a base on a bike chain because if it rusts even a little bit it’s junk.

                For woodworking why is this better than mineral spirits?

                • blackbrook@mander.xyz
                  link
                  fedilink
                  arrow-up
                  2
                  ·
                  6 hours ago

                  I don’t know about ‘better’, but I prefer it for being less fumey, I feel better about occasionally getting some on my skin, and prefer not using petroleum derivatives. I know there’s low fume mineral spirits and I’ve used that for paint cleanup, but i’m not confident it behaves the same for finishes.