Pretty sure I’m having heat creep up the Bowden tube, as it’s getting jammed a few cm back from the hot end and then can’t push the filament any more. When I get it out there’s a little molten bulb at the filament.
In this fail, I think it jammed as usual and the extruder found a way to keep going.
I tried turning down the hot end from 215 to 200 and it’s still failing. My cooling fan is running at 100%.
This is the third time I’ve had this print fail at about this layer, around 1 hour into what will be a 26 hour print.
Any ideas?
Could just be crud in the nozzle. Do a few cycles of cold pull.
Is your hotend all-metal? If not you may have a deformed PTFE liner pinching the filament path.
Last, check that the fan over the heatsink on the hotend is running.