Specifications:

  • Full size (80ish+ size with a reduced numpad will also work)
  • ISO key layout (as in, a proper Return key. ANSI can burn)
  • Numpad
  • Wireless (if possible)
  • Don’t need any RGB
  • I don’t care about keycaps, so any leftovers will do. They don’t even have to be representative of the actual key, random letters and symbols will be fine, even duplicates

When I wasbinto RC Helicopters i liked flying, but didn’t get much entertainment feom building. This other guy liked building but didn’t care that much about flying. I was hoping to run into someone similar here.

EDIT: The helicopter sory as I posted it elsewhere, in case anyone cares. https://lemmy.ml/comment/2517850

  • Pepe Godzilla
    link
    fedilink
    3
    edit-2
    1 year ago

    i think you might overestimate the building part.

    If you get a barebones board with a hotwap PCB you have to screw in stabilizers for all keys larger than 2u (=2 keys) - Shift, Enter, Backspace and Space. Since you can’t be arsed, screw lubing them. Just screw them in, takes 3 minutes.

    Then, place all the switches on Plate and PCB and since they’re hotswap you just press them in.

    Then place like 8 gaskets or screws, drop on your PCB-Plate-Switch-Sandwitch, screw together top and bottom with 4 more screws.

    When you’re done, mount the caps, also just pop them in place.

    That’s it. I reckon it’s about as much work as a 10$ Lego set.

    But going prebuilt is far easier of course: Unpack, plug in, done. If you get a hotswap you can change switches later on if you fancy.