Can I recommend digging a hole to test in. In addition to the typical hide behind a very solid wall not right next to it with some way to remotely pull the trigger. And one live round with the followup round being a dummy would also be a good bet.
But there are so many variables to test here… If it works on a smooth surface then you gotta see if it works on a surface like an oven rack. Would have to check different models as well. We just really need some semiprofessional to test this thoroughly.
I would need to ether dig a whole and also have a bullet stopping roof on it or build a four berm range. I was thinking the better way to test it would be to hand load some rounds with the same powder load and bullet weight (needed to cycle the action) but with a bullet equivalent that is not capable of much penetration (like a fine lead powder).
I think I would start with 2 rounds and the firearm fixed in place (to test if the action will cycle at all). Then go to oven with gun on baking sheet and 2 rounds. Then go oven rack and 2 rounds. And then maybe baking sheet and full mag if it all worked as theorized. I don’t think you need a way to pull the trigger since the firearm while heating is inherently in an unsafe condition, you would have to instead leave the thing to cool for a long time (also to rule out hang fires) and unload the rounds for inspection (not to be reused).
Oh I was definitely just considering testing the firearm being able to cycle the action when sitting loose on a flat surface, lol. I wasn’t anticipating getting a fully functioning oven in the hole, that does complicate the matter considerably.
Oh if I tested this it would be full on danger oven. The most expensive part would be the ruined pistols (extra difficult in my country where we can no longer legally buy new ones)
Can I recommend digging a hole to test in. In addition to the typical hide behind a very solid wall not right next to it with some way to remotely pull the trigger. And one live round with the followup round being a dummy would also be a good bet.
But there are so many variables to test here… If it works on a smooth surface then you gotta see if it works on a surface like an oven rack. Would have to check different models as well. We just really need some semiprofessional to test this thoroughly.
I would need to ether dig a whole and also have a bullet stopping roof on it or build a four berm range. I was thinking the better way to test it would be to hand load some rounds with the same powder load and bullet weight (needed to cycle the action) but with a bullet equivalent that is not capable of much penetration (like a fine lead powder).
I think I would start with 2 rounds and the firearm fixed in place (to test if the action will cycle at all). Then go to oven with gun on baking sheet and 2 rounds. Then go oven rack and 2 rounds. And then maybe baking sheet and full mag if it all worked as theorized. I don’t think you need a way to pull the trigger since the firearm while heating is inherently in an unsafe condition, you would have to instead leave the thing to cool for a long time (also to rule out hang fires) and unload the rounds for inspection (not to be reused).
Oh I was definitely just considering testing the firearm being able to cycle the action when sitting loose on a flat surface, lol. I wasn’t anticipating getting a fully functioning oven in the hole, that does complicate the matter considerably.
Oh if I tested this it would be full on danger oven. The most expensive part would be the ruined pistols (extra difficult in my country where we can no longer legally buy new ones)