Thought this was LeVar Burton.

Not quite sure what your concern is with the top fill pattern. It is a load-bearing part, so it kind of needs to be the way it is to retain the part coming out the other side. As far as the extruder exiting the perimeter of the model, I would remind you of the possibility of printing more than one model on a build plate. Although, I hadn’t yet considered trying to print only one to see if it still happens, as a troubleshooting approach. I’ll try that later, to rule out the possibility that it’s being mechanically pulled off by an extruder transport move.

It’s enclosed

I’d considered raising the temperature a little to get the perimeter to stick better to its neighbor, but I wasn’t sure if hotter printing would worsen the thermal contraction, which is what I was originally suspecting was happening. Nothing ever pulls off from an outer perimeter, it’s only inner perimeters of empty loops or holes.

It’s both first layers and higher. No pattern I can find. Bed adhesion is definitely fine, I haven’t had a single lifted corner since I started using the SuperTac plate.

It’s both first layers and higher. No pattern I can find. Bed adhesion is definitely fine, I haven’t had a single lifted corner since I started using the SuperTac plate.

It’s like Clark Kent’s glasses, but a crop-top.

No.

I’ve never understood why anyone would pre-order anything digital. Were you afraid they would run out?

Ok, but if you DID buy a restaurant, what kind and why?

Well, the original quote is usually attributed to Mother Teresa, but Britney Spears has been known to say it in interviews.

Love it.

HE SAID SWAP THE GENITALS!

I think the wording is meant to contrast how few Americans actually want it, vs, how much Trump wants it, who, as president, should, in theory as an elected figure, represent the majority opinion of the people. So, they are calling attention to the fact that it’s a low number, but for a different reason than your reading.

17% feels about right in my subjective experience.

What sort of OCD if you don’t mind me asking?

Is it also possible that what I said was hyperbolic satire?

Thank you for being the only person so far to get the hyperbolic satire. I didn’t think I needed to clarify that it was, when it was so over-the-top.

If you can’t solve all of your problems alone, then you don’t deserve to live.

…again…